Connecting The Power Cord; Remote Control Battery Installation; Loading The Batteries; Ntsc/Pal Settings - Philips DVD701AT Hook-Up Manual

16 PREPARATION

Connecting the power cord

1
Plug the female end of the supplied power cord into the Mains (AC) jack
on the rear of the player.
2
Connect the other end of the cord to an AC outlet.
Note: When the player is in the "STANDBY" mode, it is still consuming some
power. If you wish to disconnect your player completely from the power, press
POWER ON/OFF
Caution: Only qualified service personnel should remove the
cover or attempt to service this device.

Remote control battery installation

Loading the batteries

1
Open the battery compartment cover.
2
Insert batteries as indicated inside the battery compartment.
3
Close the cover.
Caution: Do not mix old and new batteries. Never mix
different types of batteries (standard, alkaline, etc.).

NTSC/PAL Settings

You can switch the NTSC/PAL setting of the DVD player to match the
video signal of your TV.This setting only affects the television's on-screen
display that shows the stop and setup modes.You may select either
NTSC or PAL.To change the DVD player setting to PAL or NTSC,
follow the steps below.
1
Press the POWER ON/OFF button on the front panel of the DVD
player to turn OFF the DVD player.
2
Press and hold / and T on the front of the DVD player.While
holding / and T, press POWER ON/OFF.
3
After PAL or NTSC appears on the display panel of the DVD player,
release / and T at the same time.The PAL or NTSC that appears on
the display panel indicates the current setting.
4
To change the setting, press T within three seconds.The new setting
(PAL or NTSC) will appear on the display panel.