Mitsubishi Electric PAR-F27MEA-US Instruction Book page 5

(3) How to operate the timer
There are the following three timer modes. Select one of them.
1) 1 day timer mode
In this mode, the ON and OFF timers (10-minute units) can each be set to one time within 24 hours.
This mode has the following three setting methods:
· ON timer operation
· OFF timer operation
· ON/OFF timer operation: Timer both starts and stops the air conditioner.
2) Daily timer mode
Operation of this mode is the same as that of the 1 day timer mode. However, timer operation can be set to the same time each day in accordance
with the set ON/OFF timer time. (ON/OFF timer each 1 time/daily)
3) Auto off timer mode
The OFF timer can be easily set in 30-minute units. (30 minutes to 4 hours range) When the remaining time reaches 0:00, the air conditioner stops.
When the Auto off timer mode is selected, the next time the air conditioner is started, the OFF timer operates automatically so that the timer can be
used to turn off the air conditioner if you should forget.
NOTE
When ON/OFF operation from the central controller, etc. was restricted when timer operation was set, the set ON/OFF timer is not executed. After the
restriction is removed, timer operation is performed at the ON/OFF time.
When ON/OFF operation was restricted during AUTO OFF timer operation, the remaining time at the point operation was restricted is memorized and the
air conditioner is stopped after the memorized remaining time from the time the restriction was removed.
CENTRALLY CONTROLLED
DRY COOL
DAILY
TIMER
AUTO OFF
AUTO FAN
CLOCK
CHECK SET TEMP.
REMAINDER
HEAT
STAND BY
ERROR CODE
DEFROST
SET TEMP.
CLOCK→ON→OFF
MODE TIMER
3
TIMER SET
PAR-F27MEA-US
When setting the current time
I Press the [Time selection] button 1 and display "CLOCK".
• Each time the button is pressed, the time is switched as shown below.
AUTO
CLOCK
ON
I Each time the [TIMER SET (
returns one minute.
• When the button is held down, the time advances or returns continuously. The time changes in 1 minute units → 10 minutes units → 1 hour units order.
• About 10 seconds after the end of setting, the remote controller display goes off.
* When a power failure occurs, the current time is reset. Reset the clock.
When performing ON timer operation (1 day timer mode/daily timer mode)
I Press the [CLOCK → ON → OFF] button 1 and check "Current time (CLOCK)" and display "Starting time (
I Set the ON time by pressing the [TIMER SET (
I Set the OFF time to "-- : --" display.
• "-- : --" display is displayed between 23 : 50 and 0 : 00.
I Press the [TIMER] button 3 and set the display to "
• Each time the button is pressed, the timer mode is switched as shown below.
Off
(1 day timer mode)
* The Auto off timer mode is skipped at the OFF window.
When performing OFF timer operation (1 day timer mode/daily timer mode)
I Press the [Time selection] button 1 and check "Current time (CLOCK)" and set the display to "Ending time (
I Set the OFF time by pressing the [Time selection (
I Set the ON time to "-- : --" display.
I Press the [TIMER] button 3 and set the display to "
: Timer only starts the air conditioner.
: Timer only stops the air conditioner.
1Hr.
SENSAOR
AUTO AUTO
INSIDE
ON OFF
FAN
SPEED
FILTER
CHECK MODE
VENTILATION
TEST RUN
LIMIT TEMP.
NOT AVAILABLE
ON/OFF
FUN SPEED AIR DIRECTION FILTER
LOUVER VENTILATION
CHECK TEST
AUTO
REMAINDER
OFF
)] button 2 is pressed, the time advances one minute and each time the [TIMER SET (
)] button 2.
) or (
" (1 day timer mode) or "
TIMER
TIMER DAILY TIMER
(Daily timer mode)
) or (
" (1 day timer mode) or "
TIMER
[Timer setting display example]
• 1 day timer mode
CENTRALLY CONTROLLED
DAILY
TIMER
AUTO OFF
CLOCK
CHECK
SET TEMP.
• Daily timer mode
CENTRALLY CONTROLLED CENTRALLY CONTROLLED
DAILY DAILY
TIMER TIMER
AUTO OFF AUTO OFF
CLOCK CLOCK
1
CHECK CHECK SET TEMP. SET TEMP.
• Auto off timer mode
CENTRALLY CONTROLLED
2
DAILY
TIMER
AUTO OFF
CLOCK
CHECK SET TEMP.
No display
" + "DAILY" (daily timer mode).
TIMER
TIMER
AUTO OFF
(Auto off timer mode)
)] button 2.
" + "DAILY" (daily timer mode).
TIMER
AUTO AUTO
← 1 day timer mode
ON OFF
8 A.M. operation start
REMAINDER
ERROR CODE
AUTO AUTO AUTO AUTO
← Daily timer mode
ON ON OFF OFF
5 P.M. daily operation stop
REMAINDER REMAINDER
ERROR CODE ERROR CODE
AUTO AUTO
← Auto off timer mode
ON OFF
Operation stop when 2 hours remain
REMAINDER
ERROR CODE
)] button 2 is pressed, the time
AUTO )".
ON
AUTO )".
OFF
5