Installer Setup Screens; Group 1 Standard Settings; Group 2 Equipment Settings; Group 3 Sensor Settings - Trane TCONT824 Installation Manual

5.4

Installer Setup Screens

From the Installer Setup screens, individual parameters are configured and modified. Use the up and down arrows to scroll
through the groups of settings. To change a setting contained in a particular group, press Edit and press Next to navigate to
the desired setting. Press Save to save changes or Exit to discard changes.

5.4.1 Group 1 Standard Settings

MENU ITEM
Outdoor Unit Type
Outdoor Unit Stages
Compressor Type
Indoor Unit Type
Indoor Heat Stages
Indoor Blower Type
SOV Operation

5.4.2 Group 2 equipment Settings

MENU ITEM
Compressor Cooling Cycles Per Hour
1st Stage Compressor Cooling Cycles Per Hour
2nd Stage Compressor Cooling Cycles Per Hour
Compressor Heating Cycles Per Hour
1st Stage Compressor Heating Cycles Per Hour
2nd Stage Compressor heating Cycles Per Hour
Indoor Heater Cycles Per Hour
1st Stage Indoor Heat Cycles Per Hour
2nd Stage Indoor Heat Cycles Per Hour
3rd Stage Indoor Heat Cycles Per Hour

5.4.3 Group 3 Sensor Settings

MENU ITEM
Select Outdoor Temperature Sensor
Calibrate Outdoor Temperature Sensor
Select Indoor Temperature Sensor
Calibrate Indoor Temperature Sensor
Calibrate Onboard Humidity Sensor
18-HD72D1-6
OPTIONS [DEFAULT]
None, [Cooling Only], Heat Pump
[Single Stage], Two Stage
Single Compressor Two Stage,
[Two Compressor Two Stage]
[Gas/Oil], Electric, Hydronic
[Single Stage], Two Stage, Three Stage
Variable, [Non - Variable]
[with Cooling Call], with Heating Call
OPTIONS [DEFAULT] DESCRIPTION
2 to 6 Cph [3]
2 to 6 Cph [3]
2 to 6 Cph [3]
2 to 6 Cph [3]
2 to 6 Cph [3]
2 to 6 Cph [5]
2 to 6 Cph [5]
2 to 6 Cph [5]
2 to 6 Cph [5]
2 to 6 Cph [5]
OPTIONS [DEFAULT]
[No ODT Sensor],
Remote ODT Sensor
-5°F to 5°F
[Onboard IDT Sensor]
Remote IDT Sensor
-5°F to 5°F
-5% - 5%
824 Programmable Wi-Fi Comfort Control
DESCRIPTION
Select the type of outdoor unit installed
Select the number of outdoor unit stages
Select the compressor type for multi-stage outdoor
units
Select the type of indoor unit installed
Select the number of indoor heat stages
Select the indoor blower type (Constant Torque motors
are considered non-variable speed)
Select which mode of operation energizes the switch-
over valve
Select the number of cycles per hour during cooling operation
Select the number of cycles per hour during 1st stage cooling
operation
Select the number of cycles per hour during 2nd stage cooling
operation
Select the minimum runtime (MRT) of stage 1 indoor heat
Select the minimum runtime (MRT) of stage 2 indoor heat
Select the minimum off time (MOT) for indoor heat operation
Select the number of cycles per hour during indoor heat operation
Select the number of cycles per hour during 1st stage indoor heat
operation
Select the number of cycles per hour during 2nd stage indoor heat
operation
Select the number of cycles per hour during 3rd stage indoor heat
operation
DESCRIPTION
Select whether an outdoor temperature sensor has been connected
Calibrate the outdoor temperature sensor
Select whether the indoor temperature is being sensed by the 824 Control
onboard sensor or wired remote sensor
Calibrate the indoor temperature sensor
Calibrate the onboard humidity sensor
27