Before Weighing; Weighing Procedures - A&D HL-1000WP Instruction Manual

Before weighing

Be aware of the Automatic power-off function.
If this unit is left ON and the stable indicator is displayed, an automatic
power-off function turns power off after approximately 5 minutes. To disable
this function, press the [ON/OFF] key while pressing the [RE-ZERO] key.
p- XX will be displayed and the scale returns to the weighing mode.
Error message
aeaaaa
a----a
albaaa
Calibration may be required before weighing
Read "CALIBRATION" first and if necessary, calibrate your scale for
accurate weighing.

Weighing procedures

1. Turn on the scale.
Press the [ON/OFF] key to turn on the scale. Then the scale displays all
segments for a few seconds and then
2. Start weighing
If you do not use a container for weighing,
Verify the reading is
0 . Place objects on the weighing platform to weigh. When the reading
becomes stable, the stable indicator is displayed.
If you use a container for weighing,
Place an empty container on the platform.
Wait for the stable indicator to be displayed and then press the
[RE-ZERO] key. Place the objects to be weighed in the container. When
the reading becomes stable, the stable indicator is displayed.
Select the weighing unit, --- Only for the "g/lb" or "g/lb-oz" model ---
If you use the "g/lb" or "g/lb-oz" model, press the [UNITS] key to select
"g" or "lb", or "g" or "lb-oz" for the weighing unit. Normally scales power up
in "lb" or "lb-oz" when shipped from the factory.
To power up with "g" selected:
Turn the scale off. Press and hold the [UNITS] key, then press the
[ON/OFF] key. The scale will start with "g". To return to the original setting
repeat this instruction.
Note: g/lb model: HL-1000WP
WEIGHING
Overload
The scale zero is out of range
Low battery
0 . If not, press the [RE-ZERO] key to display
g/lb-oz model: HL-300WP/HL-3000WP
0 will be displayed.
4