A&D HL-1000WP Instruction Manual page 4

Installing the Batteries / Connecting The AC adapter
Installing the Batteries
CAUTION
When replacing batteries, be careful
not to apply too much force to the
weighing pan. An excessive force
could damage the scale.
Remove the battery cover and insert six
batteries (R6P / LR6 / AA size) into the
battery compartment, taking extreme
care to that the polarities plus and minus
are observed.
New six batteries (R6P/ LR6/ AA size)
AC adapter (optional)
CAUTION
When using an AC adapter, the
scale doesn't comply with the IP65.
The AC input requirement could be 100,
120, 220, 230 or 240 volts (50/60Hz)
depending on the area where used, so
please verify that the adapter is correct.
Plug the AC adapter to the AC adapter
socket inside the battery compartment.
Attach the battery cover and fit the
rubber cap.
Setting up the HL-WP
CAUTION
Avoid installing the scale in direct sunlight, that may cause discoloration or
malfunctions. Place your HL-WP on a firm weighing table so that the scale
is level. (The scale will not perform accurately when it is not level.)
Place the scale on the firm surface and adjust the feet so that the sprit level
shows the scale is level for an accurate weighing.
PREPARATION
3
Stop up with
the rubber cap
Optional AC Adapter
AC Adapter jack