Key Cover Assembly; Speaker (Tweeter); Speaker Box Assembly, Speaker (Woofer) - Yamaha CLP-150 Service Manual

9.

Key Cover Assembly

(Time required : About 10 minutes)
9-1 Close the key cover.
9-2 Remove the top board assembly. (See procedure 2)
9-3 Remove the screw marked [61A]. The rack cover L can
then be removed. (Fig. 9)
* The rack cover R can then be removed in the same
manner.
9-4 Set the left end of the rod at the slits of the guide and
then lift the rear key cover assembly. (Fig. 9-1)
9-5 Lean slightly the key cover assembly so that the guide
pin can be removed from the guide rail. (Fig. 9-2)
* When removing, be sure not to make scratches on the
side cover.
* When reinstalling the key cover assembly, apply a
masking shield tape around the guide rail to prevent from
making scratches on the assembly.
[61A]: Bind Head Tapping Screw-B 3.0x8 MFZN2Y (EP600250)
(Fig. 9)
Key cover assembly
(Fig. 9-1)
Guide pin
Guide rail
(Fig. 9-2)
Rack cover L
[61A]
Rod
CLP-150/CLP-150M/CLP-150C
10.

Speaker (Tweeter)

(Time required : About 10 minutes)
10-1 Remove the top board assembly. (See procedure 2)
10-2 Remove the key cover assembly. (See procedure 9)
10-3 Remove the three (3) screws marked [61B]. The speaker
(tweeter) can then be removed. (Fig. 10)
* The left and right speaker (tweeter) each can then be
removed in the same manner.
Speaker box assembly
[53]
[53]
[61B]
[61B]: Bind Head Tapping Screw-B 3.0x8 MFZN2Y (EP600250)
[53]: Truss Head Tapping Screw-1 3.5x14 MFZN2Y (EN630230)
(Fig. 10)
11.

Speaker Box Assembly, Speaker (Woofer)

(Time required : About 15 minutes)
11-1 Remove the top board assembly. (See procedure 2)
11-2 Remove the key cover assembly. (See procedure 9)
11-3 Remove the speaker (tweeter). (See procedure 10)
11-4 Remove the six (6) screws marked [53]. The speaker
box assembly can then be removed. (Fig. 10)
* The left and right speaker box assembly each can then
be removed in the same manner.
* The phillips type screwdriver used here must be 15cm
or longer.
11-5 Remove the four (4) screws marked [68]. The speaker
(woofer) can then be removed. (Fig. 11)
Speaker (woofer)
[68]
[68]: Truss Head Tapping Screw-1 4.0x20 MFZN2Y (20338800)
(Fig. 11)
Speaker (tweeter)
[53]
[68]
9