Table of Contents
Advertisement
Timer Recording (cont'd)37
4
Use the Number
buttons (I-8) to select a slot in which to
store the timer
recording.There
are eight slots. Numbers for open
slots will flash on the screen.
NOTE."If you enter a number for a slot that has already been used ta store a
timer recording,PREVIOUSLY SETPROGRAMwill appear on the screen
briefly.Information about the program in that slot will appear on the screen.
If this happens, press the DISPLAYISTATUS/EXIT button, then select another
number.
5
Use the Number
buttons to enter theTV
channel you want
to record.
•
Cable Users, enter channel numbers as a two-digit number for the
quickest results. For example, to select channel 6, press 0,6. If you
only press the Number 6 button, channel 6 will be selected after a
brief delay.There also may be a brief delaywhen you select channels
10,_l,and 12. If you want to select channels 100 and above, enter
channel numbers as a three-digit numbeE For example, to select
channel 117, press I, 1,7.
•
Antenna Users, enter channel numbers as a two-digit number for
the quickest results. For example, to select channel 5, press 0,5. If
you only press the Number 5 button, channel 5 will be selected
after a brief delay.You may only select channels 2-69.
•
If you are recording from line input, press (3_0 to select AV REAR.
•
If you are usinga Cable Box/DBS, select the Cable Box/DBS out-
put channel (03 or 04). Set the Cable Box/DBS to the channel you
want to record. Leave the Cable Box/DBS on for the timer record-
ing.Details are on page I0.
©
v¢_
C3 133(33
.....
C_ _
C23
_C_C9
0 0 'O"'O"H_O_
PHILIPS
6
Press two Number
buttons for the hour you want the
recording
to begin. Press two Number
buttons
for the
minute
you want the recording
to begin. Press I forAM
or 2
for PM, For example, for 9:30 PM, press 09, 30, 2.
PROGRAM
I
CHANNEL
10
TIME
ON
- -
- -
TO
CORRECT
PUSH
CLEAR
END
PUSH
EXIT
7
Follow the instructions
in step 6 to enter
the recording's
stop time.
(AM or PM will be set automatically.)
PROGRAM
I
CHANNEL
10
TIME ON
0930 PM
TIME OFF
TO CORRECT
PUSH CLEAR
END PUSH EXIT
Instructions
continue
on page 38.
Helpful Hints
Entries that do not match the
DVD/VCR's clock or calendar will
cause a question mark to appear
on the screen.
If you are recording from line input,
connect the audio and video cables
to the AUDIO IN and VIDEO IN
jacks on the back of the DVD/VCR.
(Please see illustration on page 40.)
Advertisement
Table of Contents
