Mounting Instructions - D-Link DCS-4603 Quick Installation Manual

Mounting Instructions

It is highly recommended that you configure and test your camera before
mounting it.
Place the mounting sticker where you want to
position the camera.
Use a 6 mm drill bit to make the required holes
approximately 25 mm deep, then insert the wall
anchors into the holes.
If you are running the camera cables through
the wall, drill a hole in the center and pull the
cables through the hole.
Use the included wrench to loosen the 3 screws on
the top of the camera, then lift the camera cover off.
Use the screws provided to mount the camera to
the wall.
If you are running the camera cables out the
side of the camera, guide the camera cables
through the cable channel on the base.
5
D-Link DCS-4603 Quick Installation Guide