Mounting Instructions - D-Link DCS-7517 Quick Installation Manual

Mounting Instructions

It is highly recommended that you configure and test your camera before mounting it.
Place the alignment sticker where you want to position the camera. Make sure the camera
base will be positioned so that the cable channel is on the bottom.
Use a 6 mm drill bit to make the required holes approximately 25 mm deep, then insert
the wall anchors into the holes.
If you are running the camera cables through the wall, drill a hole in the center and pull
the cables through the hole.
Use the screws provided to mount the camera to the wall.
Alignment
sticker
If you are running the camera cables out the side of the
camera, guide the camera cables through the cable
channel on the base.
Connect the power and Ethernet cables, or just the
Ethernet cable if you are using a PoE connection.
If the cable bundle is not required, it can be detached from the camera, and the socket
sealed with a weatherproof cable cover.
8 8
D-Link DCS-7517 Quick Install Guide