Table of Contents
Advertisement
4.
Maintain a safe working environment. Keep the work area well lit. Make sure there is
adequate surrounding workspace. Always keep the work area free of obstructions,
grease, oil, trash, and other debris. Do not use a power tool in areas near flammable
chemicals, dusts, and vapors. Do not use this product in a damp or wet location.
5.
Avoid unintentional starting. Make sure you are prepared to begin work before turning
on the Rotary Hammer.
6.
Do not force the Rotary Hammer. This tool will do the work better and safer at the
speed and capacity for which it was designed.
7.
Always remove the battery from the Rotary Hammer before performing and
inspection, maintenance, or cleaning procedures.
8.
Never leave the Rotary Hammer unattended while running. Turn power off if you have
to leave it.
9.
Before each use, check all nuts, bolts, screws, and chuck for tightness. Vibration may
cause these to loosen.
WARNING! Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities, contain chemicals known (to the State of California) to
cause cancer, birth defects or other reproductive harm. Some examples of these chemi-
cals are: lead from lead-based paints, crystalline silica from bricks and cement or other
masonry products, arsenic and chromium from chemically treated lumber. Your risk
from these exposures varies, depending on how often you do this type of work. To
reduce your exposure to these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to
filter out microscopic particles. (California Health & Safety Code 25249.5, et seq.)
WARNING! People with pacemakers should consult their physician(s) before using
this product. Operation of electrical equipment in close proximity to a heart pace-
maker could cause interference or failure of the pacemaker.
When unpacking, check to make sure that the following parts are included:
Also refer to the Assembly section, and the Assembly Drawing and Parts List at the end of
this manual.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the
cover of this manual as soon as possible.
SKU 90827
90827.p65
5
UNPACKING
1
Rotary Hammer
1
Battery Charger Base
2
Batteries
(1)
Page 5
1
8 mm Chisel
1
25 mm Wood Bit
1
Blowmold Case
11/19/03, 9:52 AM
Advertisement
Table of Contents
