Kubota L3301 Operator's Manual page 43

7. Insert the key into the key switch and
turn it "ON".
"OFF"
"ON"
C Check Easy Checker(TM) Lamps
1. When the key is turned "ON", indicators(1)(3) should
come on. If trouble should occur at any location while
the engine is running, the indicator corresponding to
that location comes on.
2. Suppose that the engine coolant temperature is not
high enough yet. Glow plug indicator(4) also comes on
when the key is turned "ON" to preheat the engine and
goes off automatically when preheat is completed.
Illumination time of indicator varies according to the
temperature of coolant.
3. The parking brake indicator(2) comes on while parking
brake is applied and goes off when it is released.
(1) Electrical charge indicator
(2) Parking brake indicator
A Daily checks with the Easy Checker(TM) only, are not
sufficient. Never fail to conduct daily checks carefully
by referring to Daily Check. (See "DAILY CHECK" in
"PERIODIC SERVICE" section.)
"START"
(3) Engine oil pressure indicator
(4) Glow plug indicator
OPERATING THE ENGINE
A Some of the Easy Checker(TM) lamps may light up
depending on the positions of the levers and switches.
A Turn on the key, and some of the indicators stay on
about 1 second.
8. Fully depress the clutch pedal.
9. Turn the key to "START" position and
release when the engine starts.
[Manual Transmission Type]
A Because of the safety devices, the engine will not start
except when the PTO gear shift lever is in the "OFF"
position and the shuttle shift lever is in the "NEUTRAL"
position.
[HST Type]
A Because of the safety devices, the engine will not start
except when the PTO gear shift lever is placed in the
"OFF" position, speed control pedal is placed in the
"NEUTRAL" position.
10. Check to see that all the lamps on the
Easy Checker(TM) are "OFF".
If the lamp is still on, immediately stop the engine and
determine the cause.
11. Release the clutch pedal.
23