Needle Threader - Brother XL5300 Service Manual

Needle Threader

Standard
• The threading hook passes through the needle eye without interfering with left or right side on the needle
eye, this when the needle bar is in its highest position.
• A clearance of 0 - 0.1 should be between the top edge of the hook and the top edge of the needle eye.
Adjustment
1. Loosen the setscrews of the needle threader supporter .
2. Place the hook into the center of the needle eye.
3. Retighten the setscrews .
4. Loosen the setscrew of the needle threader position supporter .
5. Move the needle threader position supporter up or down to make adjustment.
6. Retighten the setscrew .
Note: Keep the needle threader position supporter parallel, to the needle bar supporter .
There should be no interference with any other part.
- 23 -