Battery Tray; Forward/Reverse Esc W/ Drag Brake; Specifications; Beep Sound And Led Status - Axial SCX10 II 2000 JEEP CHEROKEE Instruction Manual

Battery Tray

3
AX31388
AX31373
AX31373
AE-5 Forward/Reverse ESC w/ Drag Brake
Mount the ESC in an area that is well ventilated and isolated from vibration and shock.
Connect the ESC motor wires to the motor red-red & black-black.
Plug the receiver with into the throttle channel on the receiver. The black negative wire should be
towards the outside of the receiver.
Before plugging the battery into the ESC, make sure your transmitter is on and the throttle trim is set at
zero.
Connect the battery to the ESC, this will turn on the ESC.
Test forward and reverse control using the transmitter.
To calibrate the ESC, make sure the transmitter is on and the throttle control is at neutral.
Connect the battery to the ESC and wait 3 seconds to let the ESC initiate a self-test and automatic
throttle calibration.
When the ESC is ready to run a long beep sound will be emitted from the motor.
Always disconnect the battery when the vehicle is not in use.
3 AX31388 3
AX31388
AX31373
AX31373
x3
M2.6x8mm
Adjust to the appropriate range.
Suitable battery size.
5.75" x 1.2" (147mm x 32mm)
5.44" x .94" (138mm x 24mm)
8