Change Your Battery; Battery Tray Adjustment - Axial GRAVE DIGGER SMT10 Instruction Manual

Battery Tray Adjustment

1.Remove clip to open battery access door
2.Slide battery into try to check clamp height
3.Remove x4 M3x8mm AXA434 screws
Remove the body
1
2
Turn on the transmitter
Do not use a Nickel Cadmium or Nickel Metal Hydride battery charger to
charge LiPo batteries. Damage to the batteries and charger will likely
occur resulting in a fire.
Verwenden Sie keine Nickel-Cadmium-oder Nickel-Metall-Hydrid-Akku
Ladegerät LiPo-Akkus aufladen. Schäden an den Batterien und
Ladegerät wird wahrscheinlich auftreten, was zu einem Brand.
Ne pas utiliser un chargeur de batterie au nickel-cadmium ou
nickel-métal-hydrure pour recharger les batteries LiPo. Les dommages
aux batteries et le chargeur se produira probablement de provoquer un
incendie.
4.Adjust battery clamp to fit snug against battery.
5. Reinstall x4 M3x8mm screws
6. Close battery access door and insert clip
3
Install and connect the battery
4
4
Reattach the body to vehicle
Note:
Power to the vehicle is controlled
by connecting / disconnecting the
battery.
Always unplug the battery when
not in use, do not leave vehicle
stored plugged in.