HP 6125XLG Installation Manual page 6

4. Press the release tab (see callout 1 in
(see callout 2 in Figure
Figure 1 Opening the ejector lever
5. Slide the blade switch into the interconnect bay (see callout 1 in
backplane.
6. Push the ejector lever to the closed position. (See callout 2 in
Figure 2 Sliding the blade switch into the interconnect bay
7. Verify that the Health LED is green after the blade switch starts up.
Otherwise, check the installation.
8. Choose proper cables to connect to the ports on the blade switch.
For more information about ports, see "Ports." For more information about cable installation, see
"Connecting the blade switch to the
Figure 1) and then pull the ejector lever to the open position
1).
network."
2
Figure 2) until it touches the
Figure 2).