Connection; Getting Started - Philips Video Camera Installation And Operating Manual

Videor technical operating manual video camera

Table of Contents

2.6 Connection

• Connecting to the RS-485/-422

NOTE: Should you experience any control problems when using the Pelco-protocol, connect the ground plate (GND) to the control component.

The dome camera can be controlled remotely by an external device or control system, such as a control keyboard, using RS-485 half-duplex, RS-422

duplex or simplex serial communications signals. Connect Marked Rx+, Rx- to Tx+ and Tx- of the RS-485 control system.

If control system is RS-422, connect Rx+ (Tx+), Rx+ (Tx-) and Rx+, Rx- of the dome camera to Tx+, Tx- and Rx+, Rx- of the control device respectively.

• Connecting Video out connector

Connect the video out (BNC) connector to the monitor or video input.

• Connecting Alarms

AL1 to 8 (Alarm In)

You can use external devices to signal the dome camera to react on events. Mechanical or electrical switches can be wired to the AL (Alarm In) and GND

(Ground) connectors. See Chapter 3 - Program and Operation for configuring alarm input.

GND (Ground)

NOTE: All the connectors marked GND are common.

Connect the ground side of the Alarm input and/or alarm output to the GND connector.

NC(NO)1 TO 4 (Normal Close or Normal Open: Alarm Out)

The dome camera can activate external devices such as buzzers or lights. Connect the device to the NC(NO) (Alarm Out) and COM (Common) connectors.

See Chapter 3 - Program and Operation for configuring alarm output.

• Connecting the Power

Connect the power of 24VAC 850mA to the dome camera.

Use certified / Listed Class 2 power supply transformer only.

2.7 Getting Started

Once installed apply power to the dome camera. The dome camera will start a initializing sequence. When configuration is done, the following information is

displayed on the keyboard controller's LCD.

PRESET No.

TITLE

INFORMATION DISPLAY

COMMAND ON WORKING

ALARM DISPLAY

RAM TEST

CHECK NO. : OK!

CHECK AAAA : OK!

CHECK 5555 : OK!

FASTRAX II E Vx.xxx

CAMERA TYPE xxxx