Electrolux EHG6341FOK User Manual page 8

www.electrolux.com
8
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds some time and
the appliance deactivates. Remove the
object or clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before
you use the appliance again, the cook-
ing zone must be cool.
• You use incorrect cookware. The sym-
bol
deactivates automatically after 2 mi-
nutes.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off func-
tion:
•
•
•
•
4.3 The heat setting
Touch
Touch
The display shows the heat setting. Touch
and
the cooking zone.
4.4 Activation and deactivation
of the outer ring
You can adjust the surface you cook to
the dimension of the cookware.
To activate the outer ring touch the sen-
sor field
Do the procedure again to deactivate the
outer ring. The indicator goes out.
4.5 Automatic Heat Up
You can get the necessary heat setting in
a shorter time if you activate the Automat-
ic Heat Up function. This function sets the
highest heat setting for some time (see
the diagram), and then decreases to the
necessary heat setting.
To start the Automatic Heat Up function:
DeluxeAppliances - EUappliances.com
comes on and the cooking zone
comes on and the appliance
, - — 6 hours
- — 5 hours
— 4 hours
- — 1.5 hours
to increase the heat setting.
to decrease the heat setting.
at the same time to deactivate
. The indicator comes on.
1.
Touch . comes on in the dis-
play.
2.
Touch again and again until
comes on in the display.
3.
Immediately touch
again until the necessary heat setting
comes on. After 3 seconds
on in the display.
To stop the function, touch
11
10
9
8
7
6
5
4
3
2
1
0
1 2 3 4
4.6 Power function
The Power function makes more power
available to the induction cooking zones.
The Power function can be activated for a
limited period of time ( see Technical In-
formation chapter). After that, the induc-
tion cooking zone automatically sets back
to highest heat setting. To activate, touch
, comes on. To deactivate, change
the heat setting.
4.7 Power management
The power management divides the pow-
er between two cooking zones in a pair
(see the illustration). The power function
increases the power to the maximum level
for one cooking zone in the pair. The
power in the second cooking zone auto-
matically decreases. The heat setting dis-
play for the reduced zone changes be-
tween two levels.
again and
comes
.
5 6 7 8 9