Electrolux EHG6341FOK User Manual page 13

The residual heat indica-
tor does not comes on.
The Automatic Heat Up
function does not oper-
ate.
The heat setting changes
between two levels.
You cannot activate outer
ring.
The sensor fields become
hot.
on.
DeluxeAppliances - EUappliances.com
Problem
comes on.
comes on.
comes on.
and number comes
Possible cause
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot.
The highest heat setting
is set.
You decreased the heat
setting from .
The Power management
is activated.
The cookware is too large
or you put it too near to
the controls.
The Automatic Switch Off
operates.
The Child Safety Device
or the Lock function op-
erates.
No cookware is on the
cooking zone.
The cookware is incor-
rect.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
There is an error in the
appliance.
ENGLISH
Remedy
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
Start from and only in-
crease the heat setting.
Refer to "Power manage-
ment".
Activate the inner ring
first.
Put large cookware on
the rear cooking zones if
it is necessary.
Deactivate the appliance
and activate it again.
Refer to the chapter "Dai-
ly Use".
Put cookware on the
cooking zone.
Use the correct cook-
ware.
Move cookware to a
smaller cooking zone.
Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If comes on again,
speak to the service cen-
tre.
13