Troubleshooting - Silvercrest SBTF 10 C3 Operating Instructions Manual

Troubleshooting

If you cannot connect the hands-free appliance with a
compatible mobile telephone, proceed as follows:
Ensure that the Bluetooth
telephone is activated.
Is the display flashing? Ensure that the hands-free ap-
pliance is correctly installed, switched on and supplied
with electricity.
If you use several Bluetooth
a previously created Bluetooth
mobile telephone is separated. This may indicate that
a previously paired device is in range.
Ensure that the hands-free appliance is distanced a ma-
ximum of 10 metres from the mobile telephone and that
there are no barriers or electronic devices between them.
Replacing the fuse
The hands-free set is equipped with a fuse. If the device
no longer works, check the fuse and replace if necessary.
Open the vehicle connector plug
fluted screw insert
if necessary – and remove it.
Remove the plug tip
out. Ensure that the spring
plug does not accidentally jump out and become lost.
Place a new fuse of type F2AL/250V into the vehicle
connector plug
of the fuse that is slightly protruding
screw insert that you removed earlier
SBTF 10 C3
function in the mobile
®
®
D
gently anticlockwise – with pliers
A
from the fuse
B
in the vehicle connector
D
, place the plug tip
GB │ IE │ NI
appliances, ensure that
connection of the
®
C
by turning the
and pull the fuse
C
onto the end
B
and screw the
C
back in.
A
│
B A
15 ■