Ford F-650 Owner's Manual page 332

Hide thumbs Also See for F-650:
Table of Contents

Advertisement

Every 15000 miles (24000
km), 6 months, 600 engine
hours, or as indicated by the
information display
Every 30000 miles (48000
km)
Every 60000 miles (96000
km) or 2400 engine hours
Note: When adding coolant additive, do not exceed the specified maximum of 48 fluid
ounces (1.4 liters). Operating the engine with excessive coolant additive may cause
overheating which could lead to severe, permanent engine damage.
Note: After the initial coolant flush and fill at 60000 miles (96000 kilometers) or 2400
engine hours, flush and fill every 45000 miles (72000 kilometers) or 1800 engine hours
thereafter.
Frequent or extended idling (over 10 minutes per hour of normal driving) or frequent low-
speed operation if your vehicle is used for stationary operation
As required
Every 15000 miles (24000
km), six months, 600 engine
hours, or as indicated by the
information display
Every 15000 miles (24000
km) or 600 engine hours
Every 60000 miles (96000
km) or 2400 engine hours
Note: When adding coolant additive, do not exceed the specified maximum of 48 fluid
ounces (1.4 liters). Operating the engine with excessive coolant additive may cause
overheating which could lead to severe, permanent engine damage.
Note: After the initial coolant flush and fill at 60000 miles (96000 kilometers) or 2400
engine hours, flush and fill every 45000 miles (72000 kilometers) or 1800 engine hours
thereafter.
F650750 (TBC), enUSA, First Printing
Scheduled Maintenance
Towing a trailer
Replace the engine-mounted and frame-mounted fuel
filters.
Replace the wheel bearing grease and grease seals if using
non-sealed bearings.
Flush and refill the engine coolant. Do not add engine
coolant additive.
Change the engine oil and filter as indicated by the
information display, and perform the services listed in the
scheduled maintenance chart.
Replace the engine-mounted and frame-mounted fuel
filters.
Inspect the coolant concentration (freeze-point protec-
tion) and additive (corrosion inhibitor) strength. Add
engine coolant additive if necessary.
Flush and refill the engine coolant. Do not add engine
coolant additive.
329
I n f o r ma t i o n P r o v i d e d b y :

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

F-750

Table of Contents