Humidity Sensor Removal; Noise Filter Removal - Electrolux EI30MH55GBA Technical & Service Manual

Component Teardown

Humidity Sensor Removal

1. Disconnect the power supply cord and remove
the oven from wall and remove outer case. (Refer
to procedure of "Removal of Oven from Wall" and
"Outer Case Removal")
2. Open the door and block it open.
3. Remove seven (7) screws holding the hood intake
duct R to the oven cavity top plate, the oven cavi-
ty front flange, fan duct, base plate R, and mag-
netron duct. And remove the hood intake duct R.
4. Disconnect the connector CN-F of humidity
sensor from the control unit.
5. Remove the two (2) screws and one (1) washer
holding the humidity sensor to the hood duct L.
6. Release the wire lead of humidity sensor from the
holes of the hood ducts L and R.
7. Now, the humidity sensor is free.
NOTE: When the humidity sensor is reinstalled, the
wire tie of the humidity sensor should be positioned
through the hole of the oven cavity top plate (right).
Sensor ground wire
Humidity sensor
Screws
Hole
Screw
Hood duct L
Hood duct R
This illustration is under the condition which hood
intake duct R is removed.
Wire lead of humidity sensor
Hole
Hole
Wire tie
4-12

Noise Filter Removal

1. Disconnect the power supply cord and remove
the oven from wall and remove outer case.
2. Open the door and block it open.
3. Disconnect the wire leads from the terminals of
the noise filter .
4. Remove one (1) screw mounted into the noise
filter and chassis support.
5. Now the noise filter is free.
Table Tray Assembly Removal
Removal
1. Open the door and block it open.
2. Insert a putty knife into the gap between the table
tray assembly and the oven cavity front plate. And
lift up the front edge of the table tray assembly.
3. Remove the table tray assembly from the oven
cavity.
4. Now, the table tray assembly is free.
Table tray assembly
Front edge
Putty knife