Electrolux EI30MH55GBA Technical & Service Manual page 45

WARNING
TO PREVENT AN ELECTRIC SHOCK, TAKE THE FOLLOWING PRECAUTIONS.
1. BEFORE WIRING,
1) DISCONNECT THE POWER SUPPLY CORD.
2) OPEN THE DOOR BLOCK IT OPEN.
2. DON'T LET THE WIRE LEADS TOUCH TO THE FOLLOWING PARTS;
1) HIGH VOLTAGE PARTS:
MAGNETRON AND INVERTER UNIT.
2) HOT PARTS:
OVEN LAMP, HOOD LAMPS, MAGNETRON, INVERTER UNIT AND OVEN CAVITY.
3) SHARP EDGE: ALL PARTS
(BOTTOM PLATE, OVEN CAVITY, WAVEGUIDE FLANGE, CHASSIS SUPPORT AND OTHER
METALLIC PLATE.)
4) MOVABLE PARTS (TO PREVENT A FAULT)
FAN BLADE, FAN MOTOR, SWITCH, OPEN LEVER, OPEN BUTTON, STIRRER MOTORS,
STIRRER FANS, DOOR PARTS.
3. DO NOT CATCH THE WIRE LEADS IN THE OUTER CASE CABINET.
4. INSERT THE POSITIVE LOCK CONNECTOR UNTIL ITS PIN IS LOCKED AND MAKE SURE THAT
THE WIRE LEADS DO NOT COME OFF EVEN IF THE WIRE LEADS ARE PULLED.
5. TO PREVENT AN ERROR FUNCTION, CONNECT THE WIRE LEADS CORRECTLY, REFERRING TO
THE PICTORIAL DIAGRAM.
Please refer to 'OVEN PARTS, CABINET PARTS, CONTROL PANEL PARTS, DOOR PARTS', when carry-
ing out any of the following removal procedures:
THE FOLLOWING ADJUSTMENTS OR COMPONENT REPLACEMENT CAN BE PERFORMED
WITHOUT REMOVING THE OVEN FROM THE WALL
1. Oven lamp, hood lamps, hood lamp sockets, grease filter and charcoal filter.
2. Base cover, hood lamp glass assembly, bottom sash.
3. Stirrer motors.
4. Hood louver.
5. Control panel assembly or components.
6. Table tray assembly
7. Stirrer fan
8. Antenna plate assembly
9. Control unit
Component Teardown
4-5