Electrolux EI30MH55GBA Technical & Service Manual page 31

Procedure
Letter
G
BLOWN MONITOR FUSE TEST
1. Disconnect the power supply cord, and then remove outer case.
2. Open the door and block it open.
3. If the monitor fuse is blown when the door is opened, check the primary interlock switch,
secondary interlock switch and monitor switch according to the "TEST PROCEDURE" for
those switches before replacing the blown monitor fuse.
CAUTION:
If the monitor fuse is blown by improper switch operation, the monitor fuse and monitor
switch must be replaced with "monitor fuse and monitor switch assembly" part number
FFS-BA016/KIT, even if the monitor switch operates normally. The monitor fuse and monitor
switch assembly is comprised of a 20 ampere fuse and switch.
5. Reconnect all leads removed from components during testing.
6. Reinstall the outer case (cabinet).
7. Reconnect the power supply cord after the outer case is installed.
8. Run the oven and check all functions.
H HOOD THERMAL CUT-OUT TEST
1. Disconnect the power supply cord, and then remove outer case.
2. Open the door and block it open.
3. A continuity check across the thermal cut-out terminals should indicate an open circuit
unless the temperature of the thermal cut-out reaches approximately 140 F(60 C) or more.
At that temperature, the contacts will close. The thermal cut-out opens automatically at
approximately 113 F(45 C).
4. Reconnect all leads removed from components during testing.
5. Reinstall the outer case (cabinet).
6. Reconnect the power supply cord after the outer case is installed.
7. Run the oven and check all functions.
BEFORE REPLACING A BLOWN MONITOR FUSE, TEST THE PRIMARY
INTERLOCK SWITCH, SECONDARY INTERLOCK SWITCH AND MONITOR
SWITCH FOR PROPER OPERATION.
Component Test
3-7
Troubleshooting