Stirrer Motors Replacement; Stirrer Fan Assembly Installation; Hood Lamp Sockets Removal - Electrolux EI30MH55GBA Technical & Service Manual

Component Teardown

Stirrer Motors Replacement

Removal
1. Disconnect the power supply cord.
2. Open the door and block it open.
3. Remove the five (5) screws holding the bottom
sash to the base cover.
4. Remove the three (3) screws holding the base
cover to the oven cavity front face plate.
5. Open the base cover.
Stirrer motor (left one)
6. Disconnect the wire leads from the stirrer motor
(left one).
7. Remove the two (2) screws holding the stirrer
motor to the oven cavity.
8. Now, the stirrer motor (left one) is free.
Stirrer motor (right one)
6. Disconnect the wire leads from the stirrer motor
(right one).
7. Remove the two (2) screws holding the motor
mounting angle to the oven cavity.
8. Remove the two (2) screws holding the stirrer
motor to the motor mounting angle.
9. Now, the stirrer motor (right one) is free.
Reinstallation
1. Insert a putty knife into the gap between the table
tray assembly and the oven cavity front plate. And
remove the table tray assembly from the oven
cavity.
2. Install the stirrer motor (left one) to the oven
cavity with the two (2) screws.
3. Reconnect the wire lead to the stirrer motor (left
one),referring to the pictorial diagram.
4. Make sure that the stirrer motor gear, stirrer shaft
assembly and shield spring are installed to the
motor mounting angle.
5. Install the stirrer motor (right one) to the motor
mounting angle with the two (2) screws.
6. Install the motor mounting angle to the oven
cavity with the two (2) screws.
7. Reconnect the wire leads to the stirrer motor
(right one),referring to the pictorial diagram.
8. Reinstall the two (2) stirrer fans to the two (2)
stirrer shafts.
9. Reinstall the table tray assembly to the oven
cavity.

Stirrer Fan Assembly Installation

1. Make sure that the stirrer fan faces upside, as
shown in the following figure. The upside of the
stirrer fan is engraved with the part number.
2. Install the three stirrer spacers to the stirrer fan,
as shown in the following figure.
3. Install the stirrer fan to the stirrer shaft.
UPSIDE
Stirrer spacer

Hood Lamp Sockets Removal

1. Disconnect the power supply cord.
2. Open the door and block it open.
3. Remove the five (5) screws holding the bottom
sash to the base cover.
4. Remove the three (3) screws holding the base
cover to the oven cavity front face plate.
5. Open the base cover.
6. Screw the hood lamp off from the lamp socket.
7. Disconnect the wire leads from the lamp socket.
8. Push the tab holding the lamp socket to the hood
lamp mount.
9. Remove the lamp socket from the hood lamp
mount.
10. Now, the lamp socket is free.
4-10
UPSIDE
Parts number
Stirrer fan