Magnetron Removal; Hood Fan Thermal Cut-Out Removal; Oven Thermal Cut-Out Removal - Electrolux EI30MH55GBA Technical & Service Manual

Magnetron Removal

1. Disconnect the power supply cord and remove
the oven from wall and remove outer case. (Refer
to procedure of "Removal of Oven from Wall" and
"Outer Case Removal")
2. Open the door and block it open.
3. Remove the seven (7) screws holding the hood
intake duct R to the oven cavity top plate, the
oven cavity front flange, the fan duct and
magnetron duct. Remove the hood intake duct R.
4. Disconnect the high voltage wire from the
magnetron.
5. Release the two (2) tabs of the fan duct from the
base plate R.
6. Remove the magnetron duct from the oven
cavity, by releasing the tab of the magnetron duct
from the base plate R.
7. Remove the grease filter (right side one) from the
base cover.
8. Carefully remove four (4) mounting screws
holding the magnetron to waveguide. When
removing the screws hold the magnetron to
prevent it from falling.
9. Remove the magnetron from the unit with care so
the magnetron tube should not be hit by any
metal object around the tube.
CAUTION
When replacing the magnetron, be sure the R.F.
Gasket is in place and mounting screws are
tightened securely.
Component Teardown

Hood Fan Thermal Cut-out Removal

1. Disconnect the power supply cord and remove
the oven from wall and remove outer case. (Refer
to procedure of "Removal of Oven from Wall" and
"Outer Case Removal")
2. Open the door and block it open.
3. Remove the seven (7) screws holding the hood
intake duct R to the oven cavity top plate, the
oven cavity front flange, the fan duct and
magnetron duct. And remove the hood intake
duct R.
4. Disconnect the wire leads from the hood fan
thermal cut-out.
5. Remove one (1) screw holding the thermal cut-
out to the flange of base plate R.
6. Remove the hood fan thermal cut-out from the
base plate R.
7. Now, the hood fan thermal cut-out is free.

Oven Thermal Cut-out Removal

1. Disconnect the power supply cord and remove
the oven from wall and remove outer case. (Refer
to procedure of "Removal of Oven from Wall" and
"Outer Case Removal")
2. Open the door and block it open.
3. Disconnect the wire leads from the oven thermal
cutout.
4. Remove the oven thermal cut-out from the holder
at the oven cavity top plate.
5. Now, the oven thermal cut-out is free.
4-7