Information On The Display Panel; Faults And What To Do About Them - Bosch WAP Series Instruction Manual And Installation Instructions

Information on the display panel

Display
è
r
E:18
E:32
Other displays

Faults and what to do about them.

Faults
Water is leaking from the
machine.
The machine is not filling
with water.
Detergent is not being
dispensed.
The door cannot be
opened.
The program will not start.
The drum briefly jerks or
judders after the program
has started.
The water is not draining.
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
■
Close the door, continue the programme with A button or select 0 Spin/
Drain [ programme.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
Flashes (no water supply): Tap turned on? Water inlet filter blocked? Clean the
■
water inlet filter.
If an additional water filter has been installed (depending on the model), check
for contaminants and clean if required ~ separate installation and cleaning
instruction for water filter.
Water hose kinked or blocked?
Lights up (low water pressure): For information only. This will not affect the pro-
■
gramme progress. The programme duration is extended.
Drain pump blocked; clean the drain pump. Clean the drainage hose on the siphon.
Alternating display with End when programme is finished: unbalance problem, spin-
ning phase is aborted.
Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call customer services.
Cause/Remedy
Attach the drain hose correctly or replace it.
■
Tighten the screw connection of the drain hose.
■
Have you pressed the A button?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter ~ Page 22
■
If an additional water filter has been installed (depending on the
Note:
model), check for contaminants and clean if required ~ separate installa-
tion and cleaning instruction for water filter.
Is the supply hose kinked or trapped?
■
The safety function is activated. Stop the program?
■
Is the E childproof lock activated? Deactivate.
■
Is "- - - -" selected (Rinse Stop = no final spin)?
■
Can the door only be opened by the emergency release?
■
Have you pressed the A or ñ Ready in//ñ Finished in button?
■
Is the door closed?
■
Is the E childproof lock activated? Deactivate.
■
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash program starts.
Is "- - - -" selected (Rinse Stop = no final spin)?
■
Clean the drain pump ~ Page 20
■
Clean the drain pipe and/or the drain hose.
■
Faults and what to do about them.
en
23