Table of Contents
Advertisement
Pull out the detergent drawer as far
1.
as possible.
Add detergent and/or care products.
2.
Close the detergent drawer.
3.
Measuring aid* for liquid detergent
*Depending on the model
Position the measuring aid for
measuring the correct amount of liquid
detergent:
Pull out the detergent drawer. Press
1.
down the insert and fully remove the
drawer.
Slide the measuring aid forwards,
2.
fold it down and click it into place.
Reinsert the drawer.
3.
Do not use the measuring aid for
Note:
gel detergents and washing powder, or
for programmes with prewash or when
"Finish in" time is selected.
For models without a measuring aid,
pour the liquid detergent into the
appropriate dispenser and place it in
the drum.
Start the programme
Press the A button. The indicator lamp
lights up and the program starts.
The display panel shows the Finish in
time while the program is running or the
program duration and the program
progress symbols once the wash cycle
has started.
Operating the appliance
Note:
Foam detection
If the Åsymbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash cycle and automatically activated
additional rinse cycles to remove the
foam.
Add less detergent to the next wash
cycle with the same load.
If you want to lock the program to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.
Childproof lock
(E 3 sec.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock when the
program has started.
To activate/deactivate, press and hold
the 0 rpm//0 Spin Speed and ñ Ready
in//Finished in buttons at the same time
for approx. three seconds. The E
symbol appears in the display panel.
E lights up: The childproof lock is
■
active.
E flashes: The childproof lock is
■
active and the program selector has
been adjusted.To deactivate the
childproof lock, reset the program
selector to the initial program. The
symbol lights up again.
To avoid the program to
Note:
terminate, do not turn the program
selector beyond the Off position.
The childproof lock remains
Note:
active after the program has ended and
the appliance is switched off. You must
always deactivate the childproof lock if
you want to start a new program.
en
17
Advertisement
Table of Contents
