Setting The Signal; Sensors; Unbalanced Load Detection System - Bosch WAP Series Instruction Manual And Installation Instructions

M

Setting the signal

You can change the following settings:
S e t t i n g t h e s i g n a l
The volume for the information
■
signals (e.g. at the end of the
program) and/or
The volume of the audible button
■
signals.
You will need to activate the setting
mode in order to change these settings.
1/2/3/... positions on the program
selector
Activate setting mode:
Set the program selector to
1.
position 1. The washing machine is
switched on.
Press the A button and, at the
2.
same time, turn the program selector
clockwise to position 2. Release the
button.
The setting mode is activated and the
preset volume for the information
signals appears in the display panel
(e.g. at the end of the program).
Setting the signal
Changing the volume
Use the ñ Ready in//ñ Finished in + or
- button to change the following settings
at the corresponding program selector
positions:
2: The volume of the information
■
signals and/or
3: The volume of the button signals.
■
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud
Exiting setting mode
You can now end the process and set
the program selector to the Off position.
The settings are saved.
H

Sensors

U nbalanced load detection
S e n s o r s
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Place large and small items of
Note:
laundry evenly in the drum.
Faults and what to do about them
~ Page 22
en
19