Do you have a question about the GF55 and is the answer not in the manual?
Questions and answers
Ken Stanion
June 2, 2025
Is the power cord hardwired?
1 comments:
Mr. Anderson
June 2, 2025
No, the power cord of the Greenfire GF55 is not hardwired. It is a grounded electrical cord that should be connected to a standard 115 volts (4.6 Amps), 60 hertz outlet.
Page 1
Greenfire® GF55 & GFI55 OWNER'S MANUAL Freestanding and Fireplace Insert Pellet Stove GF55 WARNING: FOR YOUR SAFETY: Improper installation, adjustment, alteration, Do not store or use gasoline or other flammable s e r v i c e m a i n t e n a n c e...
Page 2
The authority having jurisdiction should be consulted before installation to determine the need to obtain a permit. Rates: This manual describes the installation and operation of the Regency GF55/GFI55 pellet heater. This heater meets the 2015 U.S. Environmental Protection Agency’s wood emission limits for wood emission limits sold after May 15, 2015.
GF55 & GFI55. We have printed a copy of the contents here for your reference. On the GF55 the safety label is located on the underside of the hopper lid. On the GFI55 the safety label is located on the hopper cover behind the top faceplate.
If this power cord should become damaged, a DAMAGE(S). replacement power cord must be purchased from the manufacture or a qualified Greenfire dealer. This unit's maximum power requirement is 520 watts. GLASS: Do not abuse the glass by striking or slamming the door. Do not attempt to operate the stove with broken glass.
Pellet quality is important, please read the following: Please read this entire Owner’s Manual before installation and op- erating your Greenfire Pellet Stove. Failure to follow these instruc- Pellet quality is a major factor in how the Pellet stove will operate.
The two most likely causes are Convection Fan failure or High Limit Switch failure. Either one needs to be properly diagnosed and rectified. Since this is a safety switch it should never be by-passed for any reason other than the service technician to test the operation. Greenfire Pellet Stove and Insert Owner's Manual...
(3) minutes before it turns off. DO NOT unplug unit while Combustion fan is operating. This may lead to smoke escaping from the stove. Starting a Fire in Your Pellet Stove Greenfire Pellet Stove and Insert Owner's Manual...
Incorrect use of the Damper will cause malfunction and poor results from your stove or insert. If all of these steps are followed, there should be no visible emissions. Starting a Fire in Your Pellet Stove Greenfire Pellet Stove and Insert Owner's Manual...
/ RTU silicone pellets burning in the drop tube and hopper. Using a metal scraper, available from your local Greenfire dealer. This is important to maintain remove material that has accumulated or is clogging the liner’s holes.
As different types of pellets produce different amounts of ash, cleaning of the tubes should be done on a regular basis to enable the unit to run efficiently. Cleaning Your Pellet Stove Figure 11: Heat Exchanger Tube Cleaner. Greenfire Pellet Stove and Insert Owner's Manual...
REPLACING DOOR GLASS side. c) Replace the burn pot and burn pot liner. It is recommended that your Greenfire dealer replace the glass if broken. d) Close the glass door and secure. The door glass is made of high temperature PYRO CERAMIC 5 mm thick.
All claims must be complete and provide full details as requested by FPI to receive consideration for evaluation. Incomplete claims may be rejected. Revision Date: December 2016 Regency Pellet Products Warranty Greenfire Pellet Stove and Insert Owner's Manual...
Page 15
Freight damages for products or parts are not covered under the terms of the warranty. Products made or provided by other manufacturers and used in conjunction with the FPI appliance without prior authorization from FPI may void this warranty. Revision Date: December 2016 Regency Pellet Products Warranty Greenfire Pellet Stove and Insert Owner's Manual...
Page 16
Thank you for choosing a Regency Fireplace. Regency strives to be a world leader in the design, manufacture, and marketing of hearth products. To provide the best support for your product, we request that you complete a product registration form at http://www.regency-fire.com/Customer-Care/Warranty-Registration.aspx within ninety (90) days of purchase. Greenfire Pellet Stove and Insert Owner's Manual...
Page 17
For fireplace care and tips and answers to most common questions please visit our Customer Care section on our Web Site. Please feel free to contact your selling dealer if you have any questions about your Regency product. Greenfire Pellet Stove and Insert Owner's Manual...
Page 18
WARRANTY Greenfire Pellet Stove and Insert Owner's Manual...
Page 19
Greenfire Pellet Stove and Insert Owner's Manual...
Need help?
Do you have a question about the GF55 and is the answer not in the manual?
Questions and answers
Is the power cord hardwired?
No, the power cord of the Greenfire GF55 is not hardwired. It is a grounded electrical cord that should be connected to a standard 115 volts (4.6 Amps), 60 hertz outlet.
This answer is automatically generated