Usb Cable Clamp - Pro-face GP4000 SERIES Installation Manual

USB Cable Clamp

When using a USB device, attach a USB cable clamp to the USB interface to
prevent the USB cable from being disconnected.
RECOMMENDATION FOR RESTRICTED AREAS
• Verify the power, input, and output (I/O) wiring are in accordance with
Class I, Division 2 wiring methods.
• Substitution of any component may impair suitability for Class I, Division 2.
• Confirm that the USB cable has been fixed with the USB cable clamp
before using the USB interface.
• Remove power before attaching or detaching any connectors to or from the
unit.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
1. Attaching the USB Cable Clamp
Note: Watch your fingers. The edge of the clip is sharp.
Step Action
1 Mount the clip to the USB mark
overlaps. The clip matches the 27 to 43.5mm [1.06 to 1.71 inch]
length of the USB connector.
2 Align the clip and the USB cable connector shell. Adjust the
position of the holes where the clip is attached. To ensure stability,
select the clip-hole position that is closest to the base of the
connector shell.
WARNING
27 to 43.5mm
[1.06 to 1.71 in.]
Pass the tie
through here.
USB Cable Clamp
connector shell so that it
31