Team Mode (Wizard™&St16) - YUNEEC Typhoon H User Manual

NOTICE: Users can control pitch, roll and yaw directions during descent. The Typhoon H
will hang over the home position at the current height when RC signal is lost.
CAUTION: You must be certain there are no obstacles in the 'Return to Home' flight path
otherwise Typhoon H may come into contact with them and crash. While
Typhoon H is in Home Mode you will have a limited amount of directional
control. To help avoid obstacles we strongly recommend to switch to Smart or
Angle Mode (then you can switch back to Home Mode).
WARNING: Home Mode only works when Typhoon H has a suitable GPS
signal/lock. If Typhoon H loses GPS signal/lock it will switch to Angle (Pilot)
Mode automatically. This is why we strongly recommend learning to fly in Angle
(Pilot) Mode as soon as possible. Otherwise, if you lose GPS signal/lock and are
not able to properly control Typhoon H in Angle (Pilot) Mode the aircraft may
crash or even 'fly away'.
IMPORTANT NOTE: Crash damage and 'fly aways' are NOT covered under warranty.
TEAM MODE (Wizard™&ST16)
The default mode of Typhoon H is single mode. The ST16 Ground Station
comes bound to the copter from the factory and controls both the copter and
the CGO3+ Gimbal Camera.
When using the Wizard and ST16 Ground Station in team mode, the Wizard
controls the copter and the ST16 Ground Station controls the CGO3+ Gimbal
Camera. The operation steps are as follows:
BINDING TYPHOON WIZARD™ TO TYPHOON H
STEP 1) Power on the ST16 Ground Station first, and then switch on Typhoon
H. Do not touch it until the initialization completes. Wait a few seconds for the
camera to align.
STEP 2) Tap the settings icon [
STEP 3) When the Main LED Status Indicator starts to blink, the copter enters
binding mode.
STEP 4) Press and hold the Power Button of the Wizard until the Aircraft Mode
LED glows solid blue. Do not release the Power Button until hearing two
beeps from the aircraft, then release it.
NOTICE: When Typhoon H is in team mode (Wizard and ST16), the Wizard
must be bound to the copter and the ST16 Ground Station must be bound to
the camera.
If you need to switch back to single mode, the operation steps
are as follows:
STEP 1) Tap the settings icon [
from team mode to single mode.
STEP 2) When the Main LED Status Indicator starts to blink, the
copter enters binding mode.
STEP 3)Wait for a few seconds, as the remote control will
automatically bind to the camera and copter. You will hear two
beeps from the aircraft when the binding is successful.
16
] and then switch from single mode to team mode.
] on the ST16 and then switch