14
O
PERATION
and instructions for safe operation.
IMPORTANT
IMPORTANT
Recoil starter: Use short pulls - only 1/2-2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold the
STARTING COLD ENGINE
1. Move ignition switch to START/RUN position.
2. Move throttle lever to IDLE position.
3. Push purge bulb 3-4 times (or until fuel is visible in fuel return
line).
4. Close choke (move choke lever up) and pull starter handle until
NOTE
Allow engine to warm up before use.
STARTING WARM ENGINE
1. Move throttle lever to IDLE position.
engine should start. Do not use choke.
NOTE
STOPPING ENGINE
1. Release throttle trigger and allow engine to run at idle for a few
minutes.
2. Move throttle lever to IDLE position.
3. Move ignition switch to "STOP" position.
WARNING
Check and repair ignition switch before starting engine again or
serious personal injury may result.
DANGER
START/RUN
Throttle lever
Choke
Purge
lever
bulb
Ignition
switch
Throttle lever
Throttle trigger
Ignition
switch
Starter
handle
STOP