Current Measurement Calibration - Aqua Computer poweradjust 3 User And Installation Manual

aqua computer
POWERADJUST 3
needs to be restarted after entering the activation key. To do so, save all settings
into the poweradjust 3 unit (by clicking the disk symbol in the device list) and shut
down your PC. Wait for a few seconds before turning the PC on again.

11.4. Current measurement calibration

11.4. Current measurement calibration 11.4. Current measurement calibration 11.4. Current measurement calibration
Due to tolerances in electronic components, the current measurement may differ
from actual current consumption. For calibration, disconnect all fans or pumps
from the power output and click the "Calibrate current measurement" button to
start the calibration process. The current measurement is a purely informative val-
ue and not relevant for control functions.
11.5. aquabus configuration 11.5. aquabus configuration 11.5. aquabus configuration 11.5. aquabus configuration
Before connecting poweradjust devices to an aquaero 5/6 controller, each power-
adjust device has to be configured to an individual aquabus address. You may
skip this step if only one poweradjust device is connected. Addresses 50 through
57 are available for poweradjust devices.
11.6. External temperature sensor 11.6. External temperature sensor
11.6. External temperature sensor 11.6. External temperature sensor
If you detect inaccuracies in the temperature sensor readings, you can make cor-
rections here. In general, this should not be necessary.
11.7. Flow sensor 11.7. Flow sensor 11.7. Flow sensor 11.7. Flow sensor
If a flow sensor is connected to the poweradjust 3 unit, set up the flow sensor input
in the lower region of the screen. The current sensor reading is displayed as well.
12. Basic settings (aquasuite) 12. Basic settings (aquasuite) 12. Basic settings (aquasuite) 12. Basic settings (aquasuite)
Click the entry „Settings" below the headline „aquasuite" to access basic settings
for language, units and start-up of the software.
12.1. Language 12.1. Language
12.1. Language 12.1. Language
Select a language from the drop down menu. After changing the language setting,
the software will have to be restarted.
12.2. Units 12.2. Units 12.2. Units 12.2. Units
Select the units to be used for temperature and flow values from the drop down
menus. After changing these settings, the software will have to be restarted.
12.3. Application start-up 12.3. Application start-up 12.3. Application start-up 12.3. Application start-up
You may customize start-up behavior to suit your preferences. You may also select
to hide the task bar symbol of the software when minimized.
- 16 - Aqua Computer GmbH & Co. KG © 2014-2016
Gelliehäuser Str. 1, 37130 Gleichen