Register Your Product - US Robotics USR5450 Installation Manual

When the Web Configuration Utility launches, you can change the information about your wire-
less network. For more information about both Configuration Utilities for the 802.11g Wireless
Turbo Multi-function Access Point, refer to the User Guide on the Installation CD-ROM.
Note: If you need to reset the Wireless Access Point at any time, perform the following
steps. Press in and hold the RESET button for between five and ten seconds. This will reset
the 802.11g Wireless Turbo Multi-function Access Point to the factory default settings.
Warning: If you reset the Wireless Access Point, you will lose your custom settings.
Congratulations!
You should now be able to connect your Wireless Access PC Cards and PCI Adapters to the Wire-
less Access Point.
For troubleshooting and technical support information, refer to the Troubleshooting section of
this Guide or to the User Guide on the U.S. Robotics Installation CD-ROM.

Register your product

• At the Installation CD-ROM interface, click the Support link. Click Registration and Warranty
and then click http://www.usr.com/productreg If the Installation CD-ROM interface does not run
automatically, click Windows Start and then click Run. In the "Run" dialog box, type D:\setup.exe.
If your CD-ROM drive uses a different letter, type that letter in place of "D."
• Or register your product online at http://www.usr.com/productreg
You have finished installing your hardware and the necessary software.
3