US Robotics USR5450 Installation Manual page 11

• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC
regulations. Modifications to this unit not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
Detachable Antenna Information
FCC Part 15, Subpart C, Section 15.203 Antenna requirement
USR 5450 users: An intentional radiator shall be designed to ensure that no antenna other than that furnished by the responsible
party shall be used with the device. The use of a permanently attached antenna or of an antenna that uses a unique coupling to
the intentional radiator shall be considered sufficient to comply with the provisions of this section. The manufacturer may design
the unit so that a broken antenna can be replaced by the user, but the use of a standard antenna jack or electrical connector is
prohibited.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20 cm between the radiator and your body.
UL Listing/CUL Listing
This Information Technology Equipment is UL Listed and C-UL Listed and is for use with UL Listed personal computers that have
Installation Instructions detailing user installation of card cage accessories.
Industry Canada Statement
This equipment complies with the Industry Canada Spectrum Management and Telecommunications policy, RSS-210, standard
Low Power License-Exempt Radio Communication Devices.
Operation is subject to the following two conditions:
1.This device may cause interference.
2.This device must accept any interference, including interference that may cause undesired operation of the device.
CE Declaration of Conformity
We, U.S. Robotics Corporation of 935 National Parkway, Schaumburg, Illinois, 60173-5157,USA, declare under our sole
responsibility that the U.S. Robotics 802.11g Wireless Turbo Multi-function Access Point to which this declaration relates is in
conformity with the following standards and/or other normative documents:
EN300 328-2
EN301 489-1
EN301 489-17
EN60950
This equipment complies with Article 3.1(a) of Directive 1999/5/EC for the protection of the health and safety of the user.
We, U.S. Robotics Corporation, hereby declare that this product is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
This product can be used in the following countries:
Germany, Austria, Belgium, Switzerland, Netherlands, Luxembourg, Italy, France, UK, Ireland, Spain, Portugal, Sweden, Norway,
Denmark, Finland, Iceland, and Greece
Regarding IEEE 802.11g we currently have the following information about restrictions in the R&TTE countries:
Country
France
This device complies with the European requirements governing exposure to electromagnetic radiation. This equipment should be
installed and operated with minimum distance 20 cm between the radiator and your body. This wireless device is a transmitter/
receiver and has been designed and manufactured to comply with the exposure limits recommended by the Council of the
European Union and the International Commission on Non-Ionizing Radiation Protection (ICNIRP, 1999) for the entire population.
The exposure standard for portable equipment uses the "Specific Absorption Rate" as unit of measure. The maximum SAR value
of this wireless device measured in the conformity test is 1.08 W/kg.
EU Detachable Antenna Information
This USR wireless device has been designed to operate with the antenna included in this package only. Together this device and
antenna combination has been tested and approved by a European Agency conforming with the European R&TTE directive 1999/
5/EC to meet the radiated power level requirement of 100mW e.i.r.p. Replacement of this antenna must only done with an
authorized USR component that has been designed and tested with the unit to the requirements of directive 1999/5/EC. Please
refer to the USR web site to get product antenna ordering information.
Manufacturer's Disclaimer Statement
The information in this document is subject to change without notice and does not represent a commitment on the part of the
vendor. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy, or fitness for
any particular purpose of this document. The manufacturer reserves the right to make changes to the content of this document
and/or the products associated with it at any time without obligation to notify any person or organisation of such changes. In no
event will the manufacturer be liable for direct, indirect, special, incidental, or consequential damages arising out of the use or
inability to use this product or documentation, even if advised of the possibility of such damages.
U.S. Robotics Corporation Two (2) Year Limited Warranty
1.0 GENERAL TERMS:
frequency band
2454-2483.5 MHz
max. output power
100 mW EIRP outdoor
7