Operation - Phantom PMR-GP1 Operating Manual

Installing the Phantom
Above the table or podium
1. Mute the audio channel for the microphone you have
selected to use with the Phantom. Remove the mic from the
base or podium and set it aside.
2. Plug the Phantom (PMR-GP1) into the same base
connector as the mic, as shown in Figure 1. The Phantom
requires phantom power - when you plug in the Phantom you
should see the LED turn green indicating phantom power is
present.
3. Plug the microphone into the top of the Phantom. Plug in
the IR Sensor and connect the cable to the gooseneck using
the supplied clips, as shown in Figure 2. For best results
install the sensor and cable with the gooseneck pointed
straight up - this will give enough slack in the cable to account
for any movement while in use.
4. If necessary you can change the orientation of the
Phantom so it conforms to the connector on your mic base or
podium. See the instructions on page 7.
5. Activate (un-mute) the mic and check for normal audio
operation. Turn to the next page and begin the Setup
Procedure.
6
GP
TM