Tips And Troubleshooting - Phantom PMR-GP1 Operating Manual

Tips and Troubleshooting

GP HH
+
1. Reset: If for any reason you need to return the
Phantom to the factory default settings, use the Phantom
tool and push both buttons simultaneously for 3 seconds.
Be careful - this also clears the FBX filters.
2. Distortion: If you hear any distortion try lowering the
Phantom's Sensitivity (SEN) setting (#1 is the lowest). You
can also try lowering the Proximity setting (PROX) to the
lowest setting (#3 is the lowest for this setting).
3. IR Sensor installation: If you plug in the sensor after
the Phantom is installed and powered up, the sensor will
not function (the mic is always on) for about 18 seconds.
If you plug in the sensor first, then power the Phantom,
the sensor works immediately.
4. The FBX may only set 2 filters. This is normal. The
Phantom will provide between two and four FBX filters
depending on system acoustics.
5. Red or green LED cycles on and off. This indicates
a problem with the phantom power source. The level may
be too low, or there may be a problem with your cable.
21