Yamaha MOXF6 Owner's Manual page 37

Setup
Determines the basic setup of the MOXF6/MOXF8 Editor. After setting necessary parameters, click [OK] to
actually apply the settings to the MOXF6/MOXF8 Editor.
1
1 [X] (Close) button
Click this to close this window without applying the settings. This button is the same as the [Cancel]
button (#).
2 [Detail] button
You can make detailed settings for the Input Port and Output Port by setting this button to "On." This
setting is necessary if the Port name is changed on a computer.
3 MIDI
Set the MIDI Port for communication between the MOXF6/MOXF8 Editor and the MOXF6/MOXF8
instrument. When the [Detail] button (2) is set to "Off," select a value such as "Yamaha USB 0" or
"MOXF6/MOXF8" at the top left column. When the [Detail] button (2) is set to "On," select Port 4 for the
MIDI In setting, then select Port 1 and Port 4 for the MIDI Out settings.
n
When "!" is shown at left of the Port name (e.g., "! Yamaha USB IN 0"), this indicates that the previously used
Port cannot be found or some Ports are not set properly. Check the MIDI Port settings in the Cubase series.
n
Keep in mind that setup on the Cubase series is necessary before making settings here.
n
Make sure to set the MIDI IN/OUT parameter to "USB" in the MIDI display of the Utility mode on the MOXF6/
MOXF8 instrument.
4 Device No.
Set the Device number to the same as the value specified in the MIDI display of the Utility mode on the
MOXF6/MOXF8 itself. When the Device number on the MOXF6/MOXF8 is set to "All," set the Device No.
here to "1."
MOXF6/MOXF8 Editor Owner's Manual
2
5
7
6
9
@
3
4
8
)
!
#
Menu: [File] menu
37