Interrupting Operation; Finish Operation; Working With Detergent - Kärcher K 2.360 Operating Instructions Manual

 Connect the high pressure hose to the
high pressure connection of the appli-
ance.
 Push the spray lance into the trigger
gun and fasten it by turning it through
90°.
 Insert the mains plug into the socket.
 Turn on the appliance "I/ON".
Operation
DANGER
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make
sure that you have a firm footing and are
also holding the trigger gun and spray lance
firmly.
 Unlock the lever on the trigger gun.
 Pull on the lever of the trigger gun; the
device will switch on.
Note: Release the lever of the trigger gun;
the device will switch off again. High pres-
sure remains in the system.
Spray lance with pressure regulation
Carrying out the most common cleaning
tasks. The work pressure can be infinitely
regulated between "Min" and "Max".
 Release the lever on the trigger gun.
 Turn the spray lance to the desired po-
sition.
Spray lance with Dirtblaster
For particularly dirty items or areas.
Not suitable for use with detergents.
Washing brush
Suitable for use with detergents.

Working with detergent

Please use exclusively KÄRCHER deter-
gents and care products to carry out the re-
spective cleaning task, as these were
specifically developed for your appliance.
The use of other detergents and care prod-
ucts may lead to premature wear and can
invalidate your warranty claims. Please ob-
tain information at your local dealer or re-
quest information directly from KÄRCHER.
 Fill the detergent solution in the deter-
gent tank (observe dosage instructions
on the packaging of the detergent).
 Use spray lance with pressure regula-
tion (Vario Power).
 Turn the spray lance to "Mix" position.
Note: This will mix the detergent with
the water stream.
Recommended cleaning method
 Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
 Spray off loosened dirt with the high
pressure jet.

Interrupting operation

 Release the lever on the trigger gun.
 Lock the lever on the trigger gun.
 During longer breaks (more than 5 min-
utes), also turn the appliance off using
the "0/OFF" switch.
 Insert the trigger gun in its holder.

Finish operation

CAUTION
Only separate the high-pressure hose from
the trigger gun or the appliance while there
is no pressure in the system.
 After operation with detergent: Fill the
detergent tank with clear water, turn the
spray lance with pressure regulator to
the position "Mix", switch the appliance
on for about 1 minute and rinse with
clear water.
 Release the lever on the trigger gun.
 Turn off the appliance "0/OFF".
 Turn off tap.
 Detach the appliance from the water
supply.
 Press the lever on the trigger gun to re-
lease any remaining pressure in the
system.
 Lock the lever on the trigger gun.
 Pull out the mains plug.
 Stow away the mains cable, the high-
pressure hose and accessory on the
appliance.
English 7