Notes On Creating Disk Images - Hitachi Compute Blade 2500 Getting Started Manual

Duration column
Transfer Rate label
Displays the speed of data transfer between the virtual media console and
the server blade.
Exit button
Exits the virtual media console. If you are connecting remotely to virtual
media from the server blade, the connection is terminated.
Add Image button
Adds the virtual media to the Client View list box.
Remove Image button
Removes the selected virtual media from the Client View list box.
Details button
Shows or hides the Details list box in the virtual media console window.
USB Reset button
The server blade and the virtual media are disconnected once, and then
connected again.

Notes on creating disk images

This section describes notes creating disk images from virtual media.
Compliance with license agreements
• Disk images of media subject to license agreements, such as operating
system installation media, are subject to the same license agreement as
the original media. Take care not to violate any license agreements.
• Disk images created using the image creation tools (FDDUMP.exe and
MakeCDImg.exe) can only be used for the virtual media functionality of
the remote console. If you use a disk image for any other purpose and
any problem arises as a result, Hitachi will accept no responsibility or
liability.
• The CD/DVD media used to create a disk image must satisfy all of the
following conditions:
¢
¢
¢
Note that even if the media satisfies all of these conditions, you might be
unable to create a disk image, depending on the compatibility between
5-12
This column displays the amount of data that the server blade has
written into the virtual media.
This column displays the length of time that the server blade has been
remotely connected to the virtual media.
It must be in ISO9660 format
It must not be multisession media
It must not have any special protection applied to it
Functionality and Operation of the Remote Console
Hitachi Compute Blade 2500 Series Getting Started Guide