Table of Contents
Advertisement
4.
Install the switch hardware. Unplug the AC power from the switch before installing the switch
hardware.
Rack mounting: Use a #1 Phillips (cross-head) screwdriver to attach the accessory kit brackets to
the switch using the eight 8-mm M4 screws. Then use the four number 12-24 screws to secure the
brackets to the rack.
NOTE:
The HPE 2530 24-port and 48-port switches can also be mounted in 4-post racks
and cabinets by using the HPE X410 Switch Rail Kit (J9583A). For instructions on using the
kit, see the documentation that is included with the kit.
Table or desktop mounting: Attach the four self-adhesive pads (included in the accessory kit) to
the bottom corners of the switch and place the switch on a secure horizontal surface.
Wall or Under-Table: Use a #1 Phillips (cross-head)
screwdriver to attach the supplied brackets to the switch
using the eight 8-mm M4 screws in the orientation shown.
For wall-mounting, the network ports must be facing up or
down. Do not mount the switch with ventilation or fan ducts
facing up or down. (See
Attach the switch to the wall or wood surface with four
5/8-inch number 12 wood or tap screws (not included).
Installation
Precautions.)
Advertisement
Table of Contents
