Trouble Shooting & Warranty; Troubleshooting - Haier HI50IB20SS User Manual

tRoUBlESHootIng

Check your problem by using the chart below and try the solutions for each problem.
tRoUBlE
The machine
doesn't operate.
The water doesn't
feed in after the
machine starts.
Machine makes ice,
but bin does not fill
up with ice.
Water is leaking out
of the unit.
Page 22 • trouble ShootIng and warranty
PoSSIBlE cAUSE
The ice maker is unplugged.
The fuse is blown.
The ice maker power button is set
at OFF.
The ice storage bin is full of ice.
The water supply tap is turned off.
The water supply pipe is not
properly connected.
The condenser may be dirty.
The air flow to the ice maker may
be obstructed.
The ambient temperature and
water temperature are high, or unit
is near some heat source.
Some water falls to the floor when
you open the door to remove ice
from storage bin.
Water supply connection is leaking.
Drain pipe higher than drain outlet.
PoSSIBlE REMEDy
Plug the ice maker in.
Replace fuse. If it happens
again, call for service to
check for a short circuit in
the unit.
Switch the ice maker power
button to ON.
Remove some ice cubes. Be
sure the ice-full probe is free
of ice.
Turn on the water supply tap.
Reconnect the water supply
pipe.
Clean the condenser.
Check the installation.
Check the installation.
Normal condensation on the
door or some water together
with ice. Take care when you
take out ice.
Tighten fitting. See
Connecting the water line.
Lower drain pipe.