Configuring, Installing, and Operating the Tape System
2.2.1
Setting the SCSI ID
Select the appropriate SCSI ID (IDs 0 through 15 are available) for the tape system by
installing jumper blocks on the pin pairs of the connector block located on the tape
system's PCBA (Figure 2-1). Refer to Table 2-1 for the allowable SCSI IDs.
A jumper must always be placed across Pin Pair 9 / 10 if
any SCSI ID other than the default (5) is selected.
Figure 2–1 Location of SCSI ID Connector Block
2-4
SCSI ID Connector Block
Quantum DLT 8000 Tape System
Front Bezel
Pin Pair 1 / 2