Disassembling The Main Unit - Epson EMP-7300 Service Manual

3.2 DISASSEMBLING THE MAIN UNIT

The flowchart for disassembling the main unit is shown below. You can take same
disassembling procedure for EMP-7300. Since you can reassemble the dismantled
parts in the reverse order of disassembly, unless specifically specified, this manual
contains no reassembly procedure. Detailed descriptions of the disassembly
procedures are given in Subsections 3.2.1 through 3.2.20.
Paragraph 3.2.19 to 3.2.20 are reference only, do not disassemble
START
Lamp inner
housing (3.2.1)
Switch Panel
(3.2.4)
Lamp Thermister
(3.2.11)
Prism duct/
LV Thermister
(3.2.12)
CD10DR head
(3.2.17)
REV.A
Air filter frame
(3.2.2)
Speaker (L/R)
(3.2.5)
CD10AU board
(3.2.6)
Safety Switch
(3.2.13)
FC board Projection lens
(3.2.18)
Figure3- 1 Disassembly flow chart
Upper case Unit
(3.2.3)
Receptor BD
(3.2.7)
Optical engine
(3.2.14)
Cooling fan/Exhaust fan/
unit
(3.2.19)
3-5
CD10MA board
(3.2.8)
Rear case unit
(3.2.9)
CD10AJ/MJ/PJ/VJ
board(3.2.10)
Power supply
unit/PBS
Thermister
(3.2.15)
Foot adjuster
(3.2.16)
optical head unit/
Left guide unit
(3.2.20)