Page 1
Owner’s Manual For The Fuller Brush BARE FLOOR Maid V acuum Model FB-BFM Thank you for purchasing this Fuller Brush Broom Vacuum. To ensure the best results, please read this manual and keep it for reference.
Save These Instructions Before you plug in your Fuller Brush vacuum cleaner, make sure the voltage indicated on the rating plate located on the back of the vacuum is the same as your local supply�...
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNING: The manufacturer cannot accept responsibility for damage caused when the appliance is not used according to the instructions, or for uses other than those for which it was intended.
Two-Wire Polarization Instructions Two-Wire Polarized Cord To reduce the risk of electric shock, this product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug.
Dust Cup Release Button (to remove dust cup from the vacuum) Dust Cup Microfiber Floor Polishing Pad Nozzle Replacement Filters & Polishing Pads • Genuine Fuller Brush High Flow Filter • Genuine Fuller Brush Microfiber Polishing Pads Part # FBQM-HFF Part # BFM-P...
body, and reliable assem heard. How to Assemble the Vacuum Attaching the Handle With the On/Off button facing the front of the vacuum, insert the handle into the top of the vacuum until it clicks into place (Fig. 1). Attaching the Dust Cup Assembly Line up the bottom of the dust cup with the base If dust cup is should of the vacuum.
How to Assemble the Vacuum Attaching the Floor Nozzle Place the floor nozzle on the floor with the neck locked in the upright position. Line up the neck of the floor nozzle with the inlet at the base of the vacuum.
How to Operate the Vacuum On/Off Button Push the power button on the handle (Fig. 1) to turn on the vacuum. Press the power button again to turn off the vacuum. Fig. 1 Reclining the Vacuum Place your foot on the top of the floor nozzle and pull the handle toward you (Fig.
If dust cup is should be rem pressed, and the dust cup sho How to Empty the Dust Cup the drawing. WARNING: Empty the dust cup after each use or before the contents reach the “MAX FILL” line on the dust cup. Over-filling the dust cup may cause dirt and debris to clog the filter and cause loss of suction.
If dust cup is should be rem pressed, and the dust cup sho How to Replace the Filter the drawing. • Remove the dust cup from the vacuum by pressing the dust cup release button on top of the dust cup (Fig. 1). •...
If dust cup is should be removed, Maintenance and Care pressed, and the dust cup should be the drawing. Cleaning the Dust Cup • Remove the dust cup from the vacuum by pressing the dust cup release button on top of the dust cup (Fig.
• Filter Make sure the filter is clean, dry and through exhaust vent. installed correctly. All other service should be performed at a Fuller Brush service center. 1-866-539-2099 For Best Performance • Keep your vacuum clean and in good operating condition.
How to Get Service: Warranty service can only be obtained by presenting the vacuum to the Fuller Brush Service Center. THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY AND ALL OTHER WARRANTIES WHETHER WRITTEN, ORAL, EXPRESSED OR IMPLIED, (INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE).
Need help?
Do you have a question about the FB-BFM and is the answer not in the manual?
Questions and answers
need a new off and on switch
new off and on switch