Page 1
Owner's Manual For The Fuller Brush Power Brush HAND V acuum Model: FB-PM Thank you for purchasing this Fuller Brush Hand Vacuum. To ensure the best results, please read this manual first and keep it for future reference.
Page 3
TABLE OF CONTENTS Important Safety Instructions Description of Vacuum Operating the Vacuum Trouble Shooting Guide...
IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNING: The manufacturer cannot accept responsibility for damage caused when the appliance is not used according to the instructions, or for uses other than those for which it was intended. To reduce the risk of fire, electric shock or injury: •...
IMPORTANT SAFETY INSTRUCTIONS • Read and follow all rating label • Using improper voltage may result in instructions. damage to the motor and possible injury to the user. Correct voltage is listed on • Keep end of hose and other openings the rating label.
DESCRIPTION OF VACUUM Shoulder strap clips Dust cup Hose clip Carrying handle release button Flexible hose On / Off switch Shoulder strap clips Power cord Dust cup Hose inlet Access to belt screw and release tab Suction inlet...
OPERATING THE VACUUM Turning the Vacuum On Hold the vacuum handle firmly in your hand and switch the power button to the “on” position indicated by the “I”. Hose Cleaning 1) To clean with the hose attachment, remove the hose from the inlet. This disables the brushroll allowing for better cleaning performance with the hose.
OPERATING THE VACUUM Emptying the Dust Cup Safety First: Always unplug from electrical outlet before opening the dust cup. The dust cup must be properly installed to operate the vacuum. 1. To open the dust cup, push the dust cup release button and pull out the dust cup.
TROUBLE SHOOTING GUIDE Problem Possible Solution Vacuum will not 1. Check to ensure unit is firmly plugged in. operate 2. Check house fuse or breaker. Replace fuse or reset breaker. 3. Check for damaged power cord. Internal thermal breaker 1. Unplug and allow unit to cool down for tripped due to overheating 30-35 minutes.
Need help?
Do you have a question about the FB-PM and is the answer not in the manual?
Questions and answers