Programming Mode; Program Menus - Curtis CLC Service Manual

Programming Mode
Entering the Programing Menus
Locate the Universal Control Module (UCM), visible on the front door (see
illustrations, right). The UCM control buttons and screen allow the user to
change the factory settings that control the product output.
To enter the programming mode, press and hold RINSE for about ten [10]
seconds until display reads Program Menus (See Photo). Release button.
Scroll through menu using ◄ or ► control button. Select menu items with
the Stop/Wash button. This button serves as a select or enter control while
you are programming the CLC unit.
IMPORTANT: Your CLC is pre-programmed and should not require reprogramming. Adjustments
should only be performed by qualified personnel.
Program Menus
*
*
To select correct tube ID, Refer to Delivery Tube section on page 3.
7