Troubleshooting; Environmental Information - Akai QXA6710 Operator's Manual

TROUBLESHOOTING

Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself,
as this will invalidate the warranty.
– Problem
• Solution
No sound /power
–Volume not adjusted
•Adjust the VOLUME
–power cord not securely connected
•Connect the AC power cord properly
–Batteries dead/ incorrectly inserted
•Insert (fresh) batteries correctly
Display does not function properly /
No reaction to operation of any of
the controls
–Electrostatic discharge
•Switch off and unplug the set. Reconnect after
a few seconds
USB no read
–No file
•To ensure your USB drive stored music file in
Mp3 or wma format.
•Reset the device

Environmental information

We have done our best to reduce the packaging and make it easy to separate into 3
Materials: cardboard, paper pulp and expandable polyethylene.
Your set consists of materials which can be recycled if disassembled by a specialized
compacts. Please observe the local regulations regarding the disposal of packaging,
dead batteries and old equipment.
no disc indication
–No CD inserted
•Insert a CD, CD-R or CD-RW
–CD badly scratched or dirty
•Replace/ clean CD, see Maintenance
–Laser lens steamed up
•Wait until lens has cleared
–CD-R is blank or the disc is not finalized
•Use a finalized CD-R
CD playback does not work
–CD badly scratched/ dirty
•Replace/ clean CD (see maintenance)
–Laser lens steamed up
•Wait until lens has adjusted to room temperature
The CD skips tracks
–CD damaged or dirty
•Replace or clean CD
–Program is active
•Quit Program mode(s)
GB-34