Inter-m DPA-150Q Operation Manual page 9

4. OUTPUT TERMIN L
Speaker Output Terminal. Before connecting speakers to the unit, be sure to disconnect the C power cable.
Make certain that the total impedance is not less than the rated impedance indicated.
- When connecting speakers to CH 1, CH 2.
....
10W 10W
- When connecting speakers to CH 3, CH 4.
....
10W 10W
※ Caution: 1. Make sure that the total impedance does not equal or less than the rated impedance.
2. Do not connects a speaker has lower impedance than rated impedance, it may cause the
problem to unit.
3. Do not put the speaker cable close to input signal cable.
5. OUTPUT VOLT GE SELECTOR SWITCH
This three-position switch is used to select a output voltage (100V / 70V / 8 ).
OUTPUT
CH 4 CH 3 CH 2 CH 1
10W 10W
OUTPUT
CH 4 CH 3 CH 2 CH 1
10W 10W
Speaker Output
150W × 4
DIGIT L POWER MPLIFIER
. . . .
10W 10W 10W
. . . .
10W 10W 10W
Speaker Impedance
100V / 66.7
70V / 32.7
34.6V / 8
DP -150Q
10W
10W
7