Panasonic CS-S9MKQ Service Manual page 47

10.1.4 How to Fix Installation Plate
The mounting wall shall be strong and solid enough to prevent if from the vibration.
S9***, S12***
S18***, S24***
The centre of installation plate should be at more than
The distance from installation plate edge to ceiling should more than
From installation plate left edge to unit's left side is
From installation plate right edge to unit's right side is
○
B : For left side piping, piping connection for liquid should be about
: For left side piping, piping connection for gas should be about
1 Mount the installation plate on the wall with 5 screws or more (at least 5 screws).
(If mounting the unit on the wall, consider using anchor bolts.)
Always mount the installation plate horizontally by aligning the marking-off line with the thread and using
o
a level gauge.
2 Drill the piping plate hole with ø70mm hole-core drill.
Line according to the left and right side of the installation plate. The meeting point of the extended line is
o
the center of the hole. Another method is by putting measuring tape at position as shown in the diagram
above. The hole center is obtained by measuring the distance namely 128mm for left and right hole
respectively.
Drill the piping plate hole at either the right or the left and the hole should be slightly slanting to the
o
outdoor side.
10.1.5 To Drill a Hole in the Wall and
Install a Sleeve of Piping
1 Insert the piping sleeve to the hole.
2 Fix the busing to the sleeve.
3 Cut the sleeve until it extrudes about 15mm
from the wall.
When the wall is hollow, please be sure to use the
sleeve for tube assembly to prevent dangers
caused by mice biting the connection cable.
4 Finish by sealing the sleeve with putty or
caulking compound at the final stage.
Model
CAUTION
Dimension
○ ○ ○
1 2 3
485mm 82mm 165mm
585mm 82mm 165mm
○
1 at right and left of the wall.
○
2 .
○
3 .
○
4 .
47
○ ○
4 5
158mm 93mm
158mm 219mm
○
5 from this line.
○
6 from this line.
○
6
145mm
269mm